2
READ THIS! Important Safety Precautions!
General:
1. Unpacking: Check the product carefully. If
it has been damaged in transit, report the da-
mage immediately by calling your dealer
and/or the shipping company that delivered
it.
2. Connections: Whenever changing, con-
necting or disconnecting signal or power
cables etc., always turn off all equipment.
This prevents transients from entering the
equipment and prevents electrical energy
from reaching you. Keep all connections out
of the reach of children. Before moving the
unit, be certain to disconnect any intercon-
nection cords with other components, and
make certain that you disconnect any powe-
red units from the AC outlet.
3. Read Instructions. All the safety and
operating instructions should be read before
the product is operated.
4. Retain Instructions. The safety and ope-
rating instructions should be retained for
future reference.
5. Heed Warnings. All warnings on the pro-
duct and in the operating instructions should
be adhered to.
6. Follow Instructions. All operating and use
instructions should be followed.
7. Water and Moisture. The product should
not be used near water – for example, near a
bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool,
and the like.
8. Accessories. To ensure proper operation
and to avoid the potential for safety hazards,
place the unit on a firm and level surface.
When placing the unit on a shelf, be certain
that the shelf and any mounting hardware
can support the product’s weight. Do not
place this product on an unstable cart, stand,
tripod, bracket, or table. The product may fall,
causing serious injury to a child or adult, and
serious damage to the product. Use only with
a cart, stand, tripod, bracket, or table recom-
mended by the manufacturer, or sold with the
product. Any mounting of the product should
follow the manufacturer’s instructions, and
should use a mounting accessory recom-
mended by the manufacturer.
9. Wall or Ceiling Mounting. The product
should be mounted on a wall or ceiling only
when and as recommended by the manu-
facturer.
10. Cleaning. Unplug this product from the
wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
11. Attachments. Do not use attachments not
recommended by the product manufacturer,
as they may cause hazards.
12. Replacement Parts. When replacement
parts are required, be sure the service tech-
nician has used replacement parts specified
by the manufacturer or that have the same
characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
13. Safety Check. Upon completion of any
service or repairs to this product, ask the
service technician to perform safety checks
to determine that the product is in proper
operating condition.
14. Feet/Spikes. When positioning, or moving
this product ensure that is lifted rather than
dragged across any floor/mounting surface.
This will avoid any damage to the floor/-
mounting surface. Attention! Products and/or
product feet constructed of rubber or plastics
may, in seldom cases, react chemically and
discolor treated or non-treated wooden sur-
faces if positioned without protection.
15. Warranty: The following conditions may
result in a void product warranty:
a. the manufacturers serial number is remo-
ved or forged.
b. if repairs and/or modifications and/or other
treatments/tunings have been carried out
by non-authorized personnel or
accessories/supplements are attached,
which are not approved by
manufacturer/importer.
16. Warranty: The following items are not
covered by the product warranty:
a. Damage caused by inappropriate handling
despite clear instructions provided in the
owners manual.
b. Damage to mechanical parts (such as
record-/playback heads, moving rubber
and plastic parts and fuses) as well as
results of normal wear and tear.
c. Damage caused by external action or
influence.
d. Damage caused by miss-use by user.
e. Damage caused by excessive electrical
mains supply voltage or lightning strike.
f. Damage caused by fire, water or smoke.
g. Damage known to buyer prior to purchase.
h. Damage caused by professional employ-
ment of home entertainment products (e.g.
for catering trade, restaurants, public ad-
dress or infinite loop announcement use
etc.)
17. Specifications: All product specifica-
tions/features are subject to change without
notification.
Passive Products:
18. Amplifiers: Amplifiers used to drive these
units must deliver a sufficient output power. A
lack of output power may lead to amplifier-
clipping, which causes damage not covered
by guarantee.
Active (Powered) Products:
19. Ventilation. Slots and openings in the
cabinet are provided for ventilation and to
ensure reliable operation of the product and
to protect it from overheating, and these
openings must not be blocked or covered.
The openings should never be blocked by
placing the product on a bed, sofa, rug, or
other similar surface. This product should not
be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is
provided or the manufacturer’s instructions
have been adhered to.
Make certain that the proper space (more
than 10cm) is provided both above and below
the unit for ventilation. If the amplifier will be
installed in a cabinet or other enclosed area,
make certain that there is sufficient air
movement within the cabinet, with means
provided for hot air to exit and for cool air to
be brought in.
Do not obstruct the ventilation slots on the
top of the unit or place objects directly over
them. Remember, power amplifiers generate
heat, and the heatsink fins and ventilation
slots that form part of the cabinet are spe-
cially designed to remove this heat. Placing
other electronic equipment near these heat-
dissipation systems may possibly affect the
long term reliability of both your amplifier and
the objects placed above it.
Do not place CDs, record jackets, owner’s
manuals or other paper on top of or beneath
the unit or in between products containing
amplifiers in a stack. This will block the air
flow, causing degraded performance and a
possible fire hazard.
20. Power Sources. This product should be
operated only from the type of power source
indicated on the marking label. If you are not
sure of the type of power supply to your
home, consult your product dealer or local
power company. For products intended to
operate from battery power, or other sources,
refer to the operating instructions.
21. Grounding or Polarization. This product
may be equipped with a polarized alternating-
current line plug (a plug having one blade
wider than the other). This plug will fit into the
power outlet only one way. This is a safety
feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If
the plug should still fail to fit, contact your
electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the
polarized plug.
22. Power-Cord Protection. Power-supply
cords should be routed so that they are not
likely to be walked on or pinched by items
placed upon or against them, paying parti-
cular attention to cords at plugs, con-
venience receptacles, and the point where
they exit from the product. To avoid safety
hazards, use only the power cord supplied
with your unit. If a replacement cord is used,
make certain that it is of a similar gauge. We
do not recommend using extension cords
with this product. As with all electrical
devices, do not run power cords under rugs
or carpets or place heavy objects on power
cords. Damaged power cords should be
replaced immediately, by a qualified service
technician, with cords meeting factory
specifications. When disconnecting the
power cord from an AC outlet, always pull the
plug; never pull the cord.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: To prevent electric shock,
do not remove the grounding plug
on the power cord, or use any plug
or extension cord that does not have
a grounding plug provided.
Make certain that the
AC outlet is properly grounded.
Do not use an adapter plug
with this product.
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the
presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to
persons.
The exclamation point within an
equilateral triangle is intended to alert
the user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.