Filter
Top Products
20
Installation of the S800 is a straight-forward process.
1. All Synthesis power amplifiers have been designed
to be mounted in EIA standard racks or stacked
freestanding.
Always put amplifiers on the bottom of a
stack.
If the S800 is being mounted in a rack, it is
suggested that its feet be removed prior to
installation. If the S800 will be stacked with
other components, use the feet that came attached
to the unit. This will ensure that there is sufficient
air space underneath so that heat can be dissipated
effectively.
2. Make sure that the amplifiers are located in a
well-ventilated, cool area. Be certain that the front
and rear panels are not obstructed, as the cooling
fan brings air in from the rear and expels it at the
front. It is very important not to obstruct the airflow
from the center front panel; heat buildup and
premature failure may occur.
5.0
PHYSICAL
CONSIDERATIONS
5.0
INSTALLING YOUR
POWER AMPLIFIER