Filter
Top Products
NOMINAL RATED OUTPUT POWER
1
:
2
ohm load/channel:
4 ohm load/channel:
8 ohm load/channel:
4 ohm bridge:
8 ohm bridge:
TYPICAL MIDRANGE OUTPUT POWER
2
:
2
ohm load:
4 ohm load:
DlSTORTlON @ RATED POWER :
1
kHz, 8 ohm load (typical):
1 kHz, 4 ohm load (typical):
20 Hz - 20 kHz, 8 ohm load:
20 Hz - 20 kHz, 4 ohm load:
Frequency Response:
Damping Factor:
Dynamic Headroom:
Noise:
Sensitivity:
Input Impedance:
CONTROLS :
Front Panel:
Rear Panel:
INDICATORS (EACH CHANNEL) :
Power:
Signal Present:
Clip:
Protect:
CONNECTORS (EACH CHANNEL) :
Input:
Output:
Cooling:
MPX1200:
MPX600:
MPX300:
Amplifier Protection:
Load Protection:
Output Circuit Type:
MPX1200:
MPX600:
MPX300:
Power Requirements:
Dimensions (HxWxD):
Net Weigbt:
Shipping Weight:
Agency Approvals:
Supplied Accessories:
Optional Accessories:
MPX300
MPX600
MPX1200
450 W
300 W
200 W
900 W
600 W
500 W
360 W
0.004%
0.007%
0.15%
0.2%
20 Hz to 20 kHz, ± 0.15 dB
Greater than 200 at 8 ohms
2.5 dB at 4 ohms
100 dB below rated output (20 Hz to 20 kHz)
1 V rms for rated power (8 ohms)
10 K ohms unbalanced, 20 K ohms balanced
850 W 1600 W
600 W
1200 W
400 W
8OO W
1700 W
3200 W
1200 W 2400 W
880 W 1640 W
700 W
1340 W
0.015%
0.020%
0.030%
0.025%
0.15%
0.15%
0.2%
0.2%
AC switcb,
Ch 1 & Ch
2
Gain
(detents
@
0
dB, -2
dB,
-4
dB, -6
dB,
-8
dB,
-10
dB,
-12
dB, -14 dB,
-18 dB, -24 dB,
∞),
Ch 1 & Ch 2 High Pass Filter switches
Slide switch for Stereo, Dual Mono (paralleled inputs) or Bridged Mono input and output configurations
Green LED
Green LED
Red LED
Red LED
XL-type 3 pin (pin 2 high)/6.3 mm (1/4 in) TRS combination connector and
removable barrier strip with separate chassis ground terminal
Binding Posts, touch resistant, accepts dual banana plugs and up to #8 AWG bare wire
Rear-To-Front Airflow (all models)
Continuously variable speed fan
Two-speed fan
Two-speed fan
Full short circuit, open circuit, ultrasonic and RF protection, current limiting, thermal muting; stable into reactive or
mismatched loads. MPX1200 additionally has thermal/clip limiting
On/off muting, DC fault load grounding relay with internal fault fuses. MPX1200 additionally has clip limiting
Complementary linear, high efficiency outputs
3 step
2 step
No step
100
V, 120 V, 220 V, or 230 V AC, 50-60 Hz (not user configurable)
133
x 483 x 408 mm (rack depth 404 mm) 5.25 x 19 x 16.1 in (rack depth
15.9
in)
18.7 kg (41 lbs)
21.5 kg (47 lbs)
29.5 kg (65 lbs)
22.3 kg (49 lbs) 25.1 kg (55 lbs)
33.1 kg (73 lbs)
UL, CSA, TUV and approved by Lucasfilm for THX
®
system installations
Gain control locking plugs
MP-RRB1
(Rear
Rack Ear Brackets, set of two)
1
Both channels driven 20 Hz - 20 kHz,120 V 60 Hz mains.
2
Typical 1 kHz @ 1% THD, 120 V 60 Hz mains.
JBL continually engages in research related to product improvement. New materials, production methods and design refinement may be introduced into
existing products without notice as a routine expression of that philosophy. For this reason, current JBL product may differ in some respect from its published
description but will always equal or exceed the original design specifications unless otherwise stated.