Filter
Top Products
5
IS5, IS6, IS8
EXISTING CONSTRUCTION
Remove the grille from the
speaker frame by pulling on
the paper tab. If the tab is
missing, to avoid scratching
the grille or baffle you may
unfold a paper clip, insert the
straight end through one of the
holes in the grille, and gently
pull up.
Determine the correct speaker
location.
Note: Remove the inner template,
which is the paint shield, at the
perforation. Use the outer tem-
plate when cutting the drywall.
Note: Always allow at least
one-half inch between a wall
stud and the speaker cutout or
the locking tabs will not be able
to swivel into place.
≥
1/2"
≥1/2"
≥1/2"
Cut the drywall.
Connect the speaker wires
to the speaker.
Replace the metal grille.
Place the frame assembly
in the wall.
Screw down each of the four
Phillips-head screws. The
locking tabs will swivel into
place and secure the unit to
the rear surface of the drywall.
JBL Performance Integrator
speakers feature unique
swivel mounts for the tweet-
ers that enable you to aim the
very directional high frequen-
cies toward the listening posi-
tion, at ear-level height.
Before installing the speaker
grille, gently press on the
outer edge of the tweeter
mount to adjust the position of
the tweeter. The tweeter will
not swivel more than 15
degrees in any direction; do
not attempt to force it to move
further. You may also rotate
the tweeter to orient the JBL
logo as desired.
Proformance Integrator OM 10/6/05 2:48 PM Page 5