Filter
Top Products
three. Operation
1. Mute
From either the front panel or
the remote control press (Mute)
to lower the volume completely.
The mute symbol indicator (27)
will begin to flash. When you
press either of the mute but-
tons again, the volume will
return to its previous setting.
Note: The mute function can
also be turned off by pressing
either of the volume buttons on
the front panel or the remote
control.
2. 0dB
Press this button to reset the
Center, Surround, Balance,
Treble, and Bass controls to
their default positions.
3. Test
Press this button to activate
the Test Tone mode (see ”Test
Tone“ section).
4. Volume
Press ( ) on the remote con-
trol or the front panel to
raise the system’s volume.
Press ( ) on the remote con-
trol or the front panel to
lower the system’s volume.
5. Center
Press (+) on the remote con-
trol to increase the relative
volume of the center channel.
Press (–) on the remote con-
trol to decrease the relative
volume of the center channel.
Master On/Off Switch
To operate unit, place this switch in the
On/Standby position. The system will go into
standby when no signal has been received for
approximately five minutes.
TM
TREBLE
BASS
INPUT
CENTER
SURROUND
BALANCE
TEST
MUTE
0dB
Video Aux
Pro
Logic
Phantom
Simulated
3 Stereo
Stereo
SURROUND
MODES
–
+
–
+
L
R
–
+
–
+
VOLUME
1
2
3
10
11
12
13
14 15
16
8
9
7
6
5
4
Remote Control
Rear Panel Control
<
<
Remote Control Battery Installation.
+
+
+
Push small tab towards
battery slot and pull battery
drawer out.
Remove old battery.
Insert new battery with "+"
side up, and slide battery
drawer back into remote.
ECS300 Simply Cinema OM 7/21/98 3:07 PM Page 6