Filter
Top Products
4 5
4 5
english
Thank you for buying a GN Netcom A/S product.
All GN Netcom A/S products are designed and manufactured in accordance with strict quality standards and
should, with a minimum of maintenance, give many years of satisfactory use.
wearing the headset with the headBand
All mono Jabra BIZ
TM
2400 models include a headband attachment. To use it:
1
2 cm
3/4"
2
1. How to wear the headband.
Place the headband over your head, with the headset positioned against your preferred ear and the T-bar
positioned just above the opposite ear. Adjust the headband for optimal t on your head.
2. How to position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less
than 2 cm from the front of your mouth.
43
3. How to rotate the boom arm.
The boom is free to rotate 360
o
.
4. How to attach the ear cushion.
Align the ear cushion with the headset ear plate so that the groove in the ear cushion slips around the ridge of
the headset ear plate. Rotating the cushion will ensure it snaps securely into place.
65
5. How to remove the headband
Remove the ear cushion by gently pulling it o the ear-plate. Push on the inner part with your thumb until the
headset clicks out of the headband.
6. How to press the headset into the headband ring on the headband.
Hold the headband in one hand and the headset in the other. Align the headset against the outside of the
headband ring with the headset cable pointing down. Gently press the headset into the headband ring until it
clicks into place.
wearing the headset with an ear hook
Two sizes of ear hook are included with some Jabra BIZ 2400 models. They can be purchased as an accessory for
any mono model. To use it:
1
2 3
R
L
1. How to attach the ear gel.
The ear gel is a round rubber part which helps stabilize the headset on your ear. Place the ear gel inside the
ear hook ring. Gently push the ear gel through the hole so that it sits in the hole. Once you click the headset
into the ear hook ring, the ear gel will be locked into place.
2. How to press the headset into its ear hook ring on the ear hook.
Hold the ear hook ring in one hand and the headset in the other. On the inside surface of the ear hook ring
you will nd "L" and "R" markings. Align the cable of the headset with the "R" marking if you wish to wear it on
you right ear, or "L" if you wish to wear it on your left ear. Gently press the headset into the ear hook ring until
it clicks into place.