Filter
Top Products
21
Using the audio
Using the projector’s speakers
Connect the audio source to the Audio 1/Audio 2 connectors to hear audio through
the projector speakers.
Amplified speakers may also be connected to the projector using the Audio Out
connector.
To adjust the volume, press the Vo
lume buttons on the remote.
Troubleshooting Audio
If you aren’t hearing the audio, check the following:
• Make sure the audio cable is connected to the Audio
1/Audio 2 connector on
the projector, and that the other end of the cable is connected to an Audio Out
connector on the source (not a “line-in” or “microphone” connector).
• Make sure the volume is turned up enough. Press the Vo
lume button on the
remote.
• Make sure the correct source is active.
• Adjust the audio source.
• If playing a video, make sure the
playback has not been paused.
connect audio cable