Filter
Top Products
29
Lamp...
Programmed Dimming:
When enabled, Programmed Dimming enhances
contrast ratios in dark scenes and disables Lamp Low Power. Programmed
Dimming will impact lamp life and system noise performance. Programmed
Dimming works in conjunction with the lamp. If Lamp Low Power is enabled,
Programmed Dimming is unavailable.
Lamp Low Power: toggles between on and of
f. Turn it on to lower the light
output of the lamp. This also lowers the fan speed, making the projector qui-
eter.
OSD Setup...
Language: allows you to select
a language for the onscreen display.
Menu Position: allows
you to change the position of the On Screen Display
items.
Menu Transparency: allows yo
u to change how much of the projected image
behind the menu you can see. As the value increases, more of the image behind
the menu is visible.
Show Messages: displays statu
s messages (such as “Searching”) in the lower-
left corner of the screen.
PIN Settings
PIN Protect:
The PIN (personal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you must
enter the PIN before you can project an image. Use the Up/Down/Left/Right
arrows buttons on the remote or keypad to set a 4-button press sequence. If you
enter an incorrect PIN 3 times in succession, the projector will automatically
shut down. If you lose or forget your custom PIN, contact InFocus Technical
Support.
To enter the PIN at projector startup:
Power up the projector. The “Enter PIN” dialog box appear
s after the startup
screen. Enter the default PIN (Left/Right/Up/Down) or the new PIN if it has
been changed, using the arrow buttons on the remote or keypad. See the
description above for instructions.
To change the PIN:
Select “Change PIN...” in
the Advanced Menu > Setup > PIN settings menu.
Enter the existing PIN. Enter the new PIN twice. Do not forget the new PIN.
Contact InFocus Support to recover a projector with a forgotten PIN.
Power
Power Saving Mode: When the Power
Saving Mode is On and the projector is
in standby (powered off but connected to AC power), external audio and the
Monitor Out function will not work.
AC Power On:
When this feature is enabled, the projector automatically turns
on when power is connected. This allows control of ceiling mounted projectors
with a wall power switch.
Instant Power On: Wh
en this feature is enabled and it has been less than 1
minute since the projector was powered down, you can turn the projector back
on immediately. When this feature is disabled, you will need to wait for the
projector lamp to completely cool before restarting the projector.
Eco Blanking:
When this feature is enabled and no video source is sensed,
70% of lamp power is saved and no image is shown. When the video source is
again applied, the image is shown immediately.
Source
Auto Source: W
hen this feature is On, the projector automatically finds the
active source, checking the selected Power-up Source first. When this feature
is Off, the projector defaults to the source selected in Power-up Source. To dis-
play another source, you must manu
ally select one by pressing the Source but-
ton on the remote or keypad and selecting one from the displayed Source
menu.
Power-up Source: det
ermines which source the projector checks first for
active video during power-up.
Search Screen:
allows you to display a blank screen instead of the default
screen at startup, and when no source is detected.