Filter
Top Products
Satellite Speaker
Infinity Logo
End Cap
1/4-20 x 3/4" Screw
Installing the TSS-SAT4000
Step One
Remove the bottom end cap of the speaker by unscrewing the
single center screw (Allen wrench included with satellite).
Step Three
Align and insert the alignment pin into the bottom of the speaker.
Step Two
Attach alignment pin to stand, and run speaker wire up stand.
NOTE: Needle-nose pliers may be required.
Alignment Pin
NOTE:The bottom is the side
closest to the Infinity logo on
the front grille.
Alignment Pin
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 2