Infinity TSS-SAT500 Speaker System User Manual


 
4
TSS-SAT500
WALL-MOUNTING
The TSS-SAT500 satellite is designed to be mounted on the wall.
There is a wall bracket included.The speaker bracket will require
four 1-1/2" #10 wood screws;each screw should be fastened to a
wall stud.If a wall stud is unavailable,install an anchor appropriate
for a 1-1/2"#10 screw.
NOTE:The customer is responsible for the correct selection and use
of mounting hardware (available through hardware stores) that will
ensure the proper and safe wall-mounting of the speakers.
Step 1.Detach shelf stand by removing screw in rear of speaker.
Step 2.Mark the positions on the wall where you would like to place
the mounting screws.
Step 3.Place bracket against the wall and fasten four 1-1/2" #10
wood screws through the bracket’s screw holes into the wall.If a
wall stud is not available,use an appropriate anchor.
Step 4.Unscrew round collar (C) from bracket (A).
A
B
C
Step 5.Screw the ball and shaft assembly (B) to 1/4"-20 insert on
rear of speaker.Back out 1/2 of a turn and tighten nut against the
speaker.
Step 6.Attach speaker wire as shown on page 5.
Step 7.Drop round collar (C) over ball and shaft assembly (B) that
is mounted to the speaker with the finished side of the collar facing
the rear of the speaker.
Step 8.Carefully push the ball straight into the socket mounted on
the wall,angle the speaker as desired and tighten the collar using
the enclosed metal bar.
Figure 3.Bracket on wall.
Metal Bar
®