Filter
Top Products
2
TSS-1200 (120V)
Read First!
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sour
ces such as
radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug.A polarized plug
has two blades with one wider than the other
.A
grounding-type plug has two blades and a third
grounding prong.The wide blade or the third
pr
ong are provided for your safety. If the provided
plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on
or pinched,
particular
ly at plugs
, convenience
receptacles and the point where they exit from the
apparatus.
11. Only use attachments/accessories specified by
the manufacturer.
12. Use only with the car
t, stand, tripod, bracket or
table specified by the manufacturer or sold with
the apparatus.When a cart is used,
use caution when mo
v
ing the
cart/apparatus combination to
avoid injury from tip-over.
13. Unplug this apparatus during lightning storms
or when unused for long periods of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
a
pparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has
been dropped.
15. Do not use attachments not recommended by
the product manufacturer, as they may cause
hazar
ds.
16. This product should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supply to your home, consult your product dealer
or local power company. For products intended to
operate from battery power, or other sources,refer
to the operating instructions.
17. If an outside antenna or cable system is
connected to the product,be sure the antenna or
cable system is grounded so as to provide some
protection against voltage surges and built-up
static charges.Article 810 of the National
Electrical Code,ANSI/NFPA 70, provides
information with regard to proper grounding
of the mast and supporting structure, grounding
of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of
antenna-discharge unit,connection to grounding
electrodes, and requirements for the grounding
electrode. See Figure A.
18. An outside antenna system should not be
located in the vicinity of overhead power lines or
other electr
ic light or power cir
cuits,
or wher
e it
can fall into such power lines or cir
cuits.When
installing an outside antenna system, extreme
care should be taken to keep from touching such
power lines or circuits,as contact with them might
b
e fatal.
19. Do not overload wall outlets, extension cords,
o
r integral convenience receptacles, as this can
result in a risk of fire or electric shock.
2
0.
N
ever push objects of any kind into this
product through openings, as they may touch
dangerous voltage points or short-out parts that
c
ould result in a fire or electric shock. Never spill
liquid of any kind on the product.
21. The apparatus shall not be exposed to dripping
or splashing, and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
22. Do not attempt to ser
vice this product yourself,
as opening or r
emoving covers may expose you to
dangerous voltage or other hazards. Refer all
ser
vicing to qualified service personnel.
23. When replacement parts are required, be sure
the service technician has used replacement parts
specified by the manufacturer or that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
24. Upon completion of any service or repairs to
this product, ask the service technician to perform
safety checks to determine that the product is in
proper operating condition.
25. The product should be mounted to a wall or
ceiling only as recommended by the manufacturer.
F
igure A.
Example of
Antenna Grounding as per
National Electr
icalCode ANSI/NFPA 70
IMPORTANT SAFETY PRECAUTIONS
TSS-1200 OM-no LED 9/27/06 2:03 PM Page 4