Filter
Top Products
SPECIFICATIONS
PS212W PS210W
Frequency Response: 25Hz – 150Hz (±3dB) 27Hz – 150Hz (±3dB)
Amplifier RMS Power: 400 Watts 300 Watts
Amplifier Peak Power
†
: 700 Watts 500 Watts
Crossover Frequencies: 50Hz – 150Hz (when activated); 50Hz – 150Hz (when activated);
24dB/octave;continuously adjustable 24dB/octave;continuously adjustable
Driver: 12" (300mm) MMD
®
10" (250mm) MMD
®
Operating Range: Up to 75' (23m),depending Up to 72' (22m),depending
upon conditions upon conditions
RF Operating Frequency: 2.4GHz 2.4GHz
Dimensions (H x W x D):
Speaker (with grille) 18" x 14-3/8" x 18-3/4" 16-3/4" x 12-1/2" x 20-7/8"
(457mm x 365mm x 476mm) (425mm x 318mm x 530mm)
Transmitter 1-1/8" x 4-7/8" x 3-7/8" 1-1/8" x 4-7/8" x 3-7/8"
(29mm x 124mm x 98mm) (29mm x 124mm x 98mm)
Weight:
Speaker 44.7 lb (20.3kg) 43 lb (19.5kg)
Transmitter 0.5 lb (0.2kg) 0.5 lb (0.2kg)
7
PS210W, PS212W (120V)
†
The peak dynamic power is measured by recording the highest center-to-peak
voltage measured across the output of a resistive load equal to minimum impedance
of the transducer,using a 50Hz sine wave burst,3 cycles on,17 cycles off.
Features,specifications and appearance are subject to change without notice.
MAINTENANCE AND SERVICE
The enclosure may be cleaned using a soft cloth to remove finger-
prints or to wipe off dust.
The grille may be gently vacuumed.Stains may be removed with an
aerosol cleaner,following its instructions.Do not use any solvents on
the grille.
All wiring connections should be inspected and cleaned or remade
periodically.The frequency of maintenance depends on the metals
involved in the connections,atmospheric conditions and other factors,
but once per year is the minimum.
In the event that your subwoofer ever needs service,contact your
local Infinity dealer,or visit www.infinitysystems.com for a service
center near you.
A Word About Wireless Products
Infinity wireless subwoofers utilize advanced wireless transceivers
operating in the 2.4GHz frequency band.This is the same frequency band
that is used for wireless home networks and high-quality cordless phones.
It also allows for the transmission of high-performance,full-spectrum
sound to remote locations,wirelessly.
Like all wireless devices,your Infinity wireless subwoofer’s operating
range may vary, depending upon variables such as building construc-
tion methods and materials,atmospheric conditions and other
sources of interference. Please consult your Infinty dealer,or visit
www.infinitysystems.com,for further information or assistance.
Wall-Mounting the Transmitter Module
NOTE:The customer is responsible for the correct selection and use
of mounting hardware (available through hardware stores) that will
ensure the proper and safe wall-mounting of the transmitter.
Step 1.
Insert the two M3 x 4 machine screws through the wall bracket and
into the rear of the transmitter module,as shown in the figure below.
Step 2.
Attach the transmitter module with wall bracket to the wall,
using suitable hardware and,if necessary,wall anchors.
PS212W.PS210W.OM 9/15/08 2:17 PM Page 7