Filter
Top Products
5
PS210W, PS212W (120V)
SYSTEM CONNECTIONS
Choose either Wireless or Wired Connection;then follow the appropriate instructions.
WIRELESS
If your receiver/processor does not contain a Dolby Digital
or DTS processor,but has subwoofer outputs:
Connecting the Subwoofer for Wired Applications
If you have a Dolby
®
Digital or DTS
®
receiver/processor with
a low-frequency effects (LFE) or subwoofer output:
NOTE: If your receiver/processor has only one sub out,you
may use either the L or R input.
WIRED
Connecting the Subwoofer for Wireless Applications
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In
›
on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet,and connect the
included power supply and power cord to the transmitter .Make
sure the Transmitter Antenna
⁄
is extended upward.
Step 3.
Set the ID Code on the transmitter
‹
and subwoofer
¢
to the
same position,as described on page 6.When connected properly,
the LED on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector
§
to the “Off”position.
NOTE: Some receivers have two subwoofer outputs.In that case,
use either connector.
Sub In
ID
CODE
DC18V
1234
PS212W.PS210W.OM 9/15/08 2:17 PM Page 5