Filter
Top Products
!
IMPORTANT!
POWER ON...
CHECKING PLAYBACK...
Figure 8. Located on each OVTR l"s
rear panel are a BASS level control
and a dual-color _PowerOn LF.D.
OPERATING THE SYSTEM
Each Compositions Overture OVTR 1 speaker system contains a built-in
powered subwoofer. For your convenience, the system is not fitted with a
power on/off switch. Instead, an auto-sense circuit will instantly switch
the system on when anaudio signal is present, and will automatically
revert to standby (drawing only 7 watts) when audio is absent for a
min'imum of 10 minutes. A dual-color'Power On_ LED (see Figure 8
below) glows red when the amplifier is the stand-by mode and green
when the amplifier is on.
If on/off switching is desired, connect the OVTR l's ac power cord to an
ac switched outlet. If you plan to leave for an extended period of time
(e.g., vacation), switch the system off (or unplug the ac power cord).
This product is designed for (USA) 120 Vac use only. Do not connect it to
any other Une voltages.
1. After speaker wiring has been completed, connect each speaker's ac
power cord to the nearest ac receptacle. You should see an LED
illuminate, indicating the amplifier is on (see Figure 8 below). If not,
verify the ac outlet is delivering power or refer to Troubleshooting on
page 8.
o
Check the speakers for playback by first setting the audio system
volume control for a minimum level, and then applying power to your
system. Play a favorite music or video segment and increase the
volume control to a comfortable level.
NOTE: You should hear balanced audio reproduction across the
entire frequency spectrum. If not, check all wiring connections and
refer to the _TroubIeshooting _section on page 8 for more help.
OVTR1
(rearview)
--m
• o°°° 4 ql° ° u ° 0 q
• • _ OVTR1
6 * Compositions Overture OVTR 1 - Owner's Manual