Filter
Top Products
5
TSS-SAT800
S
tep 4.
S
crew the ball and shaft assembly (B) to the lower 1/4"-
20 insert on the rear of the satellite. Back out 1/2 of a turn and
tighten the nut against the speaker.
Step 5.Attach the speaker wire as shown on page 6.
Step 6. Drop round collar (C) over ball and shaft assembly (B)
that is mounted to the speaker with the finished side of the
collar facing the rear of the speaker.
Step 7. Carefully push the ball straight into the socket mounted
on the wall, angle the speaker as desired and tighten the collar
using the enclosed metal bar.
Figure 3.Bracket on wall.
Metal bar
®
®
TSS-SAT800 OM 2/17/06 12:20 PM Page 5