Filter
Top Products
Infinity CC-3 Center-Channel Speaker Owner’s Manual
◆
5
TESTING THE SPEAKER
After placing and wiring the speakers, turn on audio system power.
Follow the instructions (packed with your A/V preamplifier or receiver)
to calibrate the Dolby
®
Pro Logic channels. Most components include a
built-in test tone to help you balance the sound levels to all speakers in
your system.
During calibration, verify that the CC-3 center-channel speaker
reproduces the test tone. If not, check the wiring connections and see
the Troubleshooting chart (on the next page) for help.
Once calibration is complete, audition a variety of home theater
selections and listen to the sound quality of the dialogue reproduced by
the CC-3. If you feel the CC-3 is too bright, you can reduce it by
adjusting the HIGH control (see Figure 6) from the normal “
°
” center
position towards the “–” setting. Conversely, if you want more
brightness, rotate the level control towards the “+” setting.
In a similar way, adjust the MID control to increase or decrease
midrange frequencies.
Figure 5. This wiring diagram shows
polarity connections for a center
channel connection (also see the
owner’s manual that came with your
amplifier, receiver, or television).
VERIFY TEST TONE...
A
DJUST VOICE MATCHING...
Figure 6. The CC-3 includes VOICE
MATCHING controls (on the rear) to
help match the sound coming from
the front left and right speakers.
NOTE: The normal
“
°
” center
position is typically the best match
when using other Infinity speakers in
your home theater system.
CC-3
(rear view)
Receiver or Amplifier
(rear view)
Center Out
+
–
red terminal = +
black terminal =
–
CC-3
(rear view)
CC-3
VOICE MATCHING
CONTROLS
–
HIGH
VOICE MATCHING
+
–
MID
+
CC3 Ins 9/11/98 4:00 PM Page 5