Filter
Top Products
6
INTERLUDE IL100S, IL120S
plays the tones from the test CD and records the relative output
level of each test tone, using the sound-level meter, on the
provided measurement template.After all the tones are complete,
the template contains a response curve for the frequencies
below 100Hz.The user simply notes the frequency of the largest
bass peak, calculates the correct amount of attenuation, and
uses the
“Q-Finder
”to determine the width of the curve.These
three values are dialed into the Bass Optimization System
controls located on the speaker.The entire process takes less
than twenty minutes.
If your dealer does not stock the Bass Optimization System test
and measurement kit, you may purchase it directly from Infinity.
U.S. residents can visit our Web site at www.infinitysystems.com
or call 1-800-553-3332. Canadian residents should contact
their dealer or call 1-800-567-3275.
The enclosure may be cleaned using a soft cloth, dampened with
water only, to remove fingerprints or to wipe off dust.
The grille may be gently vacuumed. Stains may be removed with
an aerosol cleaner, following its instructions. Do not use any
solvents on the grille.
All wiring connections should be inspected and cleaned or
remade periodically.The frequency of maintenance depends on
the metals involved in the connections, atmospheric conditions,
and other factors, but once per year is the minimum.
If a problem occurs, make sure that all connections are properly
made and clean. If a problem exists in one loudspeaker, reverse
the connection wires to the left and right system. If the problem
remains in the same speaker, then the fault is with the loud-
speaker. If the problem appears in the opposite speaker, the
cause is in another component or cable. In the event that your
Interlude loudspeaker system ever needs service, contact your
local Infinity dealer or Infinity directly at 1-800-553-3332 or
www.infinitysystems.com for a service center near you.
MAINTENANCE AND SERVICE