Filter
Top Products
EXISTING CONSTRUCTION
5
ERS IN-WALL SPEAKERS
ERS 210II, ERS HV250
1.Remove the plastic paint
shield from the speaker
frame.
2.Determine the correct speaker
location.
Note: Use the included template
when cutting the drywall.
3.Note:Always allow at least
one-half inch between a wall
stud and the speaker cutout or
the locking tabs will not be
able to swivel into place.
≥1/2"
≥1/2"
≥
1/2"
4.Cut the drywall.
5.Connect the speaker wires
to the speaker.
8.Attach the metal grille.
6.Place the speaker
assembly in the wall.
7.Screw down each of the six
Phillips head screws.The locking
tabs will swivel into place and
secure the unit to the rear
surf
ace of the dr
yw
all.
ERS 110II, ERS 110DT,ERS 310
1.Remove the plastic paint
shield from the speaker frame.
≥
1/2"
≥
1/2"
≥1/2"
4.Cut the drywall.
5.Connect the speaker wires
to the speaker
.
6.
Place the fr
ame assembly
in the wall.
7.Screw down each of the
f
our Phillips head scr
ews.The
locking tabs will swivel into
place and secure the unit to
the r
ear surf
ace of the
dr
yw
all.
8.
Attach the metal gr
ille
.
3.
Note:Always allow at least
one-half inch between a wall
stud and the speaker cutout or
the locking tabs will not be
able to swivel into place.
2.Determine the correct speaker
location.
Note: Use the included template
when cutting the drywall.