Infinity ERS 210II Speaker User Manual


 
3
ERS IN-WALL SPEAKERS
INSTALLATION
T
he ERS Series in-wall speakers were designed to be easily
installed.However,if you are unsure of your ability to properly
install these loudspeakers,please contact your dealer or a
qualified installer.
Tools Needed
PLACEMENT
Stereo
Bef
ore deciding where to place your ERS Series speakers,survey
your r
oom and think about placement,keeping the following
points in mind,and using Figure 1,on previous page,as a guide:
• For best results,place the speakers 6'–8' apart.
When installing in the wall,position each speaker so that the
tweeter is as close to ear level as practical.
• Refer to “Home Theater”below if you also plan to use the
speakers in a home theater system.
Home Theater
For front-channel use,place one speaker on the left and another
on the right along either side of the television.
A center channel speaker should go dir
ectly above or below the
television and can be an in-wall or freestanding center channel.
For left and right surround channels,place one speaker on the
left and another on the right,to the side of or slightly behind the
listening area.The surround speakers should be mounted at a
height of between 4 feet and 7 feet.
In 6- or 7-channel configurations,place the rear channel(s)
behind the listening position,as shown in Figure 3.
Note:An Infinity powered subwoofer will add impact and
realism to both music and film soundtracks.Contact your
Infinity dealer for recommendations on subwoofer models for
your application.
Proper placement of the speakers is an important step
in obtaining the most realistic soundstage possible.These
recommendations are for the optimal placement of the loud-
speakers.Use these placement recommendations as a guide.
Slight variations will not diminish your listening pleasure.
Phillips #2 screwdriver
Measuring tape
Utility knife
Pencil
Carpenter’s level
Awl