Filter
Top Products
6
ERS IN-WALL SPEAKERS
NEW CONSTRUCTION
If you wish to preinstall a rough-in frame before the drywall
is installed,you will need to purchase the correct rough-in-frame
kit for your model:
Speaker Model Rough-In-Frame Kit
ERS 110II,ERS 110DT ERS 110RIF or IW6R RIF
ERS 210II ERS 210RIF
ERS 310 IW8R RIF
ERS HV250 IW55 RIF
Detailed installation instructions are supplied with the
rough-in kit.
Painting the Speaker Frame and Grille
ERS Series loudspeakers can be painted to match any décor.
If you wish to change their color,the satin finish on the grille
and frame will function as a primer coat. Before painting,install
the paint shield (inner section of template in the assembly kit)
securely into the recess in the baffle.This will protect the
speaker components and baffle from paint residue.Use a
high-quality spray paint, and apply a thin coat of color.
Be certain the grille perforations remain free of paint.
Filling them with paint will diminish the sound quality.
Note:
Gently remove the acoustical foam blanket from
the grille before painting.Reattach the blanket after the
paint has dried.
OPERATION
Surround Modes
W
hen using the system in a Dolby* Digital or DTS
®
home theater
system,
make sure all speakers are set to “Small.”When using
the ERS Series in a Dolby Pro Logic* home theater system,
make sure the receiver’s center channel mode is set to “Normal.”
Some Dolby Digital-equipped r
eceivers/processors offer different
setup options for each source or surround mode:e.g.,CD-stereo,
videotape,Dolby or Pro Logic.In each case,follow your
equipment’s instructions to ensure that the subwoofer (if you have
one) output is turned on and that the speakers are set to “Small”
in each mode.