Filter
Top Products
6
CS SERIES
EXISTING CONSTRUCTION
CS 50, CS 60
1. Remove the grille from
the speaker frame.
2. Determine the correct
speaker location.
NOTE: Remove the inner
template, which is the paint
shield, at the perforation. Use
the outer template when cutting
the drywall.
3. NOTE: Always allow at least
one-half inch between a wall
stud and the speaker cutout or
the locking tabs will not be
able to swivel into place.
≥1/2"
≥1/2"
≥1/2"
4. Cut the drywall.
5. Connect the speaker
wires to the speaker.
8. Replace the metal grille.
6. Place the speaker
assembly in the wall.
7. Screw down each of the
Phillips head screws.The
locking tabs will swivel into
place and secure the unit to the
rear surface of the drywall.
1. Remove the grille from the
speaker frame.
≥1/2"
≥1/2"
≥1/2"
4. Cut the drywall.
5. Connect the speaker wires to
the speaker. Model CS 60RDT
requires two sets of speaker
wires, one for each channel.
6. Place the frame
assembly in the wall.
7. Screw down each of the four
Phillips head screws.The
locking tabs will swivel into
place and secure the unit to
the rear surface of the drywall.
8. Replace the metal grille.
3. Determine the correct speaker
location.
NOTE: Always allow at least one-
half inch between a wall stud
and the speaker cutout, or the
locking tabs will not be able to
swivel into place.
CS 60R, CS 60RDT, CS 80R
Template
2. Determine the correct
speaker location.
NOTE: Remove the inner
template, which is the paint
shield, at the perforation. Use
the outer template when
cutting the drywall.
CS50-60-80 OM 8/6/04 1:18 PM Page 6