Filter
Top Products
3
TSS-800 (230V)
Adjustable Wall Bracket
Step 1. Mark the positions on the wall where you would like to place
the mounting screws.
Step 2. Place bracket against the wall and fasten four 1-1/2" #10
wood screws through the bracket’s screw holes into the wall.If a wall
stud is not available,use an appropriate anchor.
Step 3. Unscrew round collar (C) from bracket (A).
A
B
C
Step 4. Screw the ball and shaft assembly (B) to the lower 1/4"-20
insert on the rear of the satellite,or the upper insert on the rear of
the center channel.Back out 1/2 of a turn and tighten the nut
against the speaker.
Step 5.Attach speaker wire as shown on page 4.
Step 6. Drop round collar (C) over ball and shaft assembly (B) that is
mounted to the speaker with the finished side of the collar facing the
rear of the speaker.
Step 7. Carefully push the ball straight into the socket mounted on
the wall,angle the speaker as desired and tighten the collar using
the enclosed metal bar.
Figure 3.Bracket on wall.
Metal bar
®