Filter
Top Products
ZN10_14 IB_060807.fh10 2/12/08 10:12 AM Page 5
3
Using Your iHome
Connect Unit to Power Source
Plug the AC adaptor cable into the ᕩ AC Adaptor Jack on the back of the unit and the other end into a standard 120VAC
wall outlet.
Install Zune Insert
Your unit comes with a removable insert to ensure your Zune fits properly in the ᕡ Dock.
USE PROPER INSERT TO AVOID DAMAGE TO Zune OR UNIT.
Playing and charging your Zune
1. Place proper insert for your Zune in ᕡ Dock, then gently dock Zune. When docked, Zune will charge until fully charged.
The Zune will not overcharge.
2. Turn the ᕤ Function Knob to Zune and press play on Zune to play.
3. Turn the ᕢ Volume Knob clockwise to turn on the unit (Power On LED will light) and adjust the volume. Set the ᕨ EXB
Switch to On for sound boost.
4. To switch off the unit, turn the ᕢ Volume Knob fully counter-clockwise.
Listening to Radio
Setting Up Antennas
1. Snap AM loop antenna into provided stand, then plug antenna cable into the ᕥ AM Antenna socket on back of the unit.
Move antenna 12” away from the unit and rotate it for best reception.
2. Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antenna.
Tuning and Playing the Radio
1. Turn the ᕤ Function Knob to AM or FM to select AM or FM radio band.
2. Turn the ᕢ Volume Knob clockwise to turn on the unit (Power On LED will light) and adjust the volume. Set the ᕨ EXB
Switch to On for sound boost.
3. Turn the ᕣ Tuning Knob to tune radio to the desired station.
4. To switch off the unit, turn the Volume Knob fully counter-clockwise.
Using the Aux-in Jack
1. Plug one end of the audio patch cord (included) into the headphone or line-out jack on your nondocking Zune or other
audio device and the other end of the patch cord into the ᕦ Aux-in Jack located on the back of the unit.
2. Turn the ᕤ Function Knob to AUX.
3. Turn the ᕢ Volume Knob clockwise to turn on the unit (Power On LED will light) and adjust the volume. Set the ᕨ EXB
Switch to On for sound boost.
4. To switch off the unit, turn the Volume Wheel fully counter-clockwise.
Using the Headphones Jack
1. Plug your headphones into the ¶ Headphones Jack located on the back of the unit for private listening to any selected
function (Zune, radio or aux). Speaker output is disabled when headphones are plugged in.
2. Turn the ᕢ Volume Knob clockwise to turn on the unit (Power On LED will light) and adjust the volume. Set the ᕨ EXB
Switch to On for sound boost.
3. To switch off the unit, turn the Volume Knob fully counter-clockwise.