Filter
Top Products
4
Using the iP87
Reviewing, Arming and Disarming Alarm (Turn Alarm Function On and Off)
1. Once an alarm is armed, the lower part of the display will show the alarm time. If more then one alarm is armed, the earliest alarm
time will show.
2. To review the alarm time, press an alarm button once. The related alarm time will show on the lower part of the display.
3. During alarm review, press the alarm button once to toggle it on or off. If the alarm is armed, the related alarm icon will light up.
Resetting the Alarm to Come on the Next Day
1. When the alarm is sounding, press the Button to stop alarm and reset it to come on the next set day. For example, if alarm is set
for 5 days and you press the alarm reset on Friday, the alarm will come on again on Monday, not Saturday.
Snooze Operation
1. Press and hold the Snooze/Dimmer Button for a few seconds until the snooze time flashes. Turn the Set Wheel to set the snooze
timer from 1 to 29 minutes.
2. Press the Snooze/Dimmer Button after an alarm sounds. The alarm will be silenced for the set snooze duration time then sound
again. Snooze can be pressed several times during the 1 hour alarm cycle.
Sure Alarm
The iP87 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of a power failure.
Charging your iPhone/Pod
Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP87. Failure to do
so may damage your iPhone/iPod.
1. While an iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged).
Listening to iPhone/iPod
1. Dock the already playing iPhone/iPod in the dock. The iP87 will automatically turn on and you will hear the music playing from your
iPhone/iPod.
Note: If the playing song/music loudness is too low on the iPod itself, the iP87 may not detect iPod is in play mode. Press the Button
to play it.
2. When an iPhone/iPod is docked and in standby mode, press the Button to play it.
3. Press the Button again to pause play; press again to resume it.
5. Turn the Volume Wheel to adjust the system volume.
6. Press the EQ Button to select and turn the Set Wheel to set Treble, Bass,3D Sound on/off and Left/Right Balance.
7. To turn off the unit, press the Button. An iPhone/iPod will continue charging while docked.
Listening to Radio
Setting up Antenna
Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Snap AM antenna cable into AM Loop Antenna Socket on back of unit. Move antenna 12” away from unit for best reception.
Tuning and Playing the Radio
1. Press the Radio Button as needed to turn on iP87 and cycle through FM radio, AM radio and Line-in modes.
2. When the desired FM or AM mode is selected, turn the Set Wheel to tune the radio to a desired station. The current radio frequency
appears in the lower right of the display.
3. To memorize a station as a preset, use the Set Wheel to tune the radio to the first station you wish to memorize. When the desired
station appears in the display, press and hold the Preset 1-2 button until PRE 1 begins flashing in the display. Press again to alternately
switch between Preset 1 and Preset 2 if desired, then release the button. After 5 seconds the P 1 or P 2 indicator disappears and your
station is saved in Preset Memory 1 or 2. Repeat this procedure to enter stations in Preset Memories 3 through 6. You may then press
the Radio Button to change bands and memorize up to 6 additional stations.
4. To access a preset station, press the desired Preset Button once (for odd number presets) or twice (for even number presets).
5. Turn the Volume Wheel to adjust the system volume.
6. Press the EQ Button to select and turn the Set Wheel to set Treble, Bass,3D Sound on/off and Left/Right Balance.
7. To turn off the unit, press the Button. An iPhone/iPod will continue charging while docked.