Filter
Top Products
5
Batteries Installation
Install/Replace Batteries
The iH20 uses 4 “AA” batteries for portable playing. If sound becomes weak or distorted, it is time to replace the batteries.
The iH20 will not charge your iPod while operating on batteries.
• Open the battery compartment cover located inside the unit above the iPod dock.
• Insert 4 “AA” batteries as indicated.
• We recommend the use of alkaline batteries for longer life.
NOTE: AC adaptor does not charge batteries
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.
Using the Line-in and Headphone Jacks
a) An audio patch cord comes with the iH20. Use it to play nondocking iPod models
or other audio devices through the iH20
ᕧ
Line-in Jack (one end in the device’s
line out or headphones jack, the other in the iH20 line in jack).
WARNING: Connector pins are for iPod ONLY. DO NOT attempt to connect any
device other than an iPod to the connector socket in the dock. Use
Line-in and audio cord instead.
Make sure there is no iPod connected to the iH20 when using the
ᕧ
line-in jack.
Press the
ᕤ
PLAY button to mute or unmute line-in source.
NOTE: Other than mute and volume, the iH20 does not control line in audio
devices.
b) Use the
ᕨ
Headphone Jack on the iH20 to disable the speakers and listen to your iPod privately.
SPULPU