Filter
Top Products
ADJUSTING AIR FLOW DIRECTION
TEMP
CLOCK
SPEED
MODE
FAN
SPEED
ON
OFF
TEMP
C
Adjust the air flow direction
Adjust the horizontal louver using the remote controller.
Adjust the vertical louver manually.
The air conditioner automatically adjusts the vertical air
flow direction in accordance with the operating mode.
Perform this function while the unit is in operation.
Keep pressing the AIR DIRECTION button on the remote
controller to move the louver to the desired direction.
Adjust the vertical air flow direction to the desired direction.
In subsequent operations, the vertical air flow is
automatically set in the direction to which you adjusted
the louver by pressing the AIR DIRECTION button.
room temperatures.
Adjusting the Vertical Air Flow Direction (up - down)
To set the vertical air flow direction
to maximize comfort and provide
even
Lever
Adjust the vertical louver manually using the lever on the
left or right side of the vertical louver arm (Depending on
model). Take care not to catch fingers on the fan, horizontal
louver or to damage vertical louvers. When the air
conditioner is in operation and the horizontal louver is in
a specific position, move the lever at left (or right, depending
on model) end of the air outlet to the desired position.
Perform this function while the air conditioner is in operation.
Press the SWING button on the remote controller.
To stop the function, press the SWING button again.
Press AIR DIRECTION button to lock louver in desired
position.
To set the horizontal air flow direction (left - right)
To automatically swing the air flow direction (up - down)
5
The AIR DIRECTION and SWING buttons will be disabled when the air
conditioner is not in operation (including when the TIMER is set).
Do not operate the air conditioner for long periods the air flow
direction set downward in cooling or dry mode. Otherwise,
may occur on the surface of the horizontal
louver causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the AIR
DIRECTION or SWING button. If you move this louver manually, it
may malfunction during operation. If the louver malfunctions, stop
the air conditioner once and restart it.
When the air conditioner is started immediately after it was stopped,
the horizontal louver might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as
COOLING or HEATING performance may be impaired due to too
restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the
horizontal louver may generate a sound for 10 seconds, this is a
normal operation.
ON
with
condensation
CAUTION
!