Filter
Top Products
i
CONNECTbNG
/SZA
CMNG POWER TOURmAMPS
i
If you have a second POWER TOURTM amp (sold separately). you can c
two amplifiers. Doing so doubles your sound!
Take the cable that came with the second POWER
TOURTM AMP, and plug on
into the "OUT" jack of the first amplifier: plug the other end of this cable into the
I!
'IN
1"
jack of the second amplifier.
Once you have the two POWER TOURTM AMPS connected, you may plac
amplifier on top of the other amplifier: you'll see that the four pads on t
of one amplifier fit comfortably into four tabs on the top of the other amplifier.
-
This does not lock the two amplifiers together: so
be
careful not to knock or push them over!
-
Control the tone and volume of each amp with each amplifier's Tone and ~olum&
knob. If you have two or more amps connected together, it is a good idea to set
each amp at the same volume: this equalizes the sound.
Use the Volume knob on your guitar (not included) to control guitar output. If you
kt,
ant to play loud, set each amplifier at the same high volume, then turn up the
volume of your guitar: use the Tone knobs
.
on each of the amps to adjust for the
best sound.
'Auto-Off' Feature
If you don't play any music through the amplifier for about
15
minutes. the amplifier
will
enter a 'sleep state"
(conserving battery life, should you forget to turn the amplifier
off).
To wake the amp back up. play some music
through the amplifier. (The
amplifier might not pick up low-volume music,
so
you might have to play a couple of
loud notes.) You could also switch the power switch off, then back on again, to wake up the amplifier. If you're not
going to play through your amplifier for a while. however, it's best to turn it
off,
to conserve battery life.