Harman-Kardon Home Theater System Home Theater System User Manual


 
10
OPERATION
Move the Master Power switch (marked
“Power” ¡) to the “
(On) position to
use the subwoofer.The HKTS 2 subwoofer
will automatically turn itself on or go into
standby (sleep) mode when left in the
standby mode (“Auto/On” switch in the
“Auto” position).When your receiver or
amplifier is off, or is not sending program
material to the subwoofer, the subwoofer
will be in standby mode and the LED will
turn red.When the sub
woofer senses an
audio signal,
it will automatically turn itself
on and the LED will turn green. If the
subwoofer does not sense a signal after
approximately twenty minutes,
it will
automatically go into standby mode.
When the “Auto/On” switch is switched
to the “On” position, the subwoofer will
remain on, whether or not program material
is playing.
If you will be away from home for an
extended period of time, or if the sub-
woofer will not be used, switch the Master
Power switch ¡ to the “Off” position.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
¡
This area is designed to be quite warm
during normal operation.
SUB-TS 2
AC 120V~60Hz
200W
FUSE
2.5A/250V
TYPE T
L
LINE
LEVEL
INPUT
R
SUB
HIGH
LEVEL
OUT
IN
+
R
L
+
MIN MAX
RED: STAND BY —
O
— GREEN: ON
ON n
AUTO n
£
™
SUBWOOFER
LEVEL
POWER
IMPORTANT: CONNECT STRIPED WIRE TO RED
(
+
)
SPEAKER TERMINAL.
Volume
Volume can be adjusted using the
Subwoofer Level Control
£, as shown
below.
MIN MAX
Subwoofer
Level
MIN MAX
Subwoofer
Level