Filter
Top Products
MOUNTING OPTIONS 7
ENGLISH
Wall-Mounting for Satellites
Unscrew the bolt that attaches the black shelf
stand to the bottom of the speaker. Store the
stand and bolt in a safe place in case they are
needed for a future installation.
Mount the wall-bracket attachment plate on the
wall in the desired location.
If possible, position the speakers so that the
mounting screws (not included; use size #8) may
be installed directly into a wooden wall stud.
If that is not possible, use optional wall anchors
that are rated to support at least twenty-five
pounds. The customer is responsible for
proper selection and use of mounting
hardware, available through hardware
stores, to properly and safely wall-mount
the speakers.
Referring to the speaker connection instructions
on pages 8 through 11, thread the appropriate
speaker cable through the opening in the
bottom of the attachment plate, and then
through the back of the bracket as shown in the
diagram.
The bracket has two openings on top: a round
screw hole, and an arc-shaped opening in front
of it.The speaker cable should be threaded
through the arc-shaped opening, not the screw
hole.
Attach the bracket to the wall plate by inserting
the tab at the top of the attachment plate into
the slot on top of the bracket and snapping the
bracket onto the attachment plate.
Thread the cable through the round opening in
the terminal cover, and then insert the speaker
wires into the terminals on the underside of the
speaker, remembering to observe the correct
polarity (see page 8).
Place the terminal cover over the opening on the
underside of the speaker so that it fits flush
against the speaker and covers the terminals,
with its round opening exposing the threaded
insert.The bracket fits through the round open-
ing in the terminal cover.
Insert the supplied bracket bolt up through the
bottom of the bracket and terminal cover, and
screw it into the threaded insert on the under-
side of the speaker.The bolt should be snug, but
not so tight as to prevent the bracket from
pivoting.
The wall-mounted speaker may be pivoted from
side to side; however, the bracket is not
designed to tilt up or down, and attempting to
tilt it will damage the bracket and possibly the
wall, which would not be covered by your war-
ranty.
Wall-Mounting for the Center
Speaker
Remove the two black rubber patches from the
bottom of the center speaker. Keep the patches
in a safe place in case they are needed for a
future installation.
The back of the bracket has two small round
screw holes on each side, and a large opening
for the cable.
Position the bracket in such a way that the large
hole for the cable is in front of the hole in the
wall that holds the cable. Thread the cable
through the hole and fix the bracket on the wall.
The mounting screws (not included; use size #8)
may be installed directly into a wooden wall
stud. If that is not possible, use optional wall
anchors that are rated to support at least twen-
ty-five pounds.The customer is responsible for
proper selection and use of mounting hardware,
available through hardware stores, to properly
and safely wall-mount the center.
Insert the appropriate center speaker wires into
the terminals on the backside of the center,
remembering to observe the correct polarity (see
page 8). Place the center speaker on the wall-
bracket and use the enclosed screws to fix the
center speaker on the bracket from the bottom.
The wall-bracket cannot be pivoted from side to
side.The bracket is not either designed to tilt up
or down, and attempting to tilt it will damage
the bracket and possibly the wall, which would
not be covered by your warranty.
Wall
23mm
or 3/4"
(M6–1.25P
or 1/4"–20)
Wall Bracket
Wires to Speaker
Terminal Cover
Overhead
View
Wire
From
Wall
Plate
Wall Plate
Remove
Stand
15mm
or 1/2"
Mounting Options
Wires to
Speaker