Filter
Top Products
WARNING- Never allow the player to stand for long
periods in direct sunlight or near any heat source.
CONNECTIONS
REMOTE CONTROL
The IRIS CD has two recessed male connectors on the
back panel. They are internally connected together to
allow the IRIS digital data-bus to “daisy-chain” to other
IRIS-compatible accessories.
Connect either end of the supplied ribbon-type umbilical
cable to either of the CD’s connectors. Note that both of
the cable’s connectors are keyed, and therefore fit only one
way. Be sure to insert the plugs fully. Connect the free
end of the cable to the connector on the rear of (either) the
IRIS Preamp or IRIS Tuner.
AUDIO
Output Right/Left: For the signal output to the preamplifier.
Connect a standard RCA-type patch cord from the right
and left outputs into the corresponding CD input jacks of
your IRIS preamplifier.
Digital: For digital output signal to an outboard Digital to
Analog (A/D) converter.
POWER
For AC line (mains) power. Make sure the line voltage on
the rear of the unit is appropriate for your location.
OPERATION
EXPLANATION OF KEYS (Refer to Figure 1)
1. POWER button
For switching on and off.