Filter
Top Products
5
A M P L I F I E R C O N T R O L S
There is no power ON/OFF switch at the connector. As soon as the amplifier is connected to
AC line and if the amplifier has not detected an error previously, the yamplifier is receiving
current. but can be in one of four modes; STANDBY, ON, OFF or ERROR. (see Manual
Operation section).
The TELOS 200 may be powered on either manually (Manual Operation) or automatically
when receiving a signal (Auto-Power Operation). This is selected internally by the small
white 10-position circular selector located on the top circuit of the amplifier, close to the big
capacitors.
There is one position for Manual operation and 9 for Auto-Power operation. Positions 1
through 8 enable various delays to be set. This supports powering-up a quantity of amplifiers
without a big surge on the AC line.
Position 0: Manual Operation
Position 1: Power after 200ms
Position 2: Power after 400ms
Position 3: Power after 600ms
Position 4: Power after 800ms
Position 5: Power after 1s
Position 6: Power after 1.2s
Position 7: Power after 1.4s
Position 8: Power after 1.6s
Position 9: Power after 1.8s
User manual - GOLDMUND TELOS 200 UNIVERSAL POWER AMPLIFIER
| P 7