Filter
Top Products
Two Subwoofers (mono) in
three channel LCR mode.
To combine the subwoofers into the
system so that both subwoofers
produce the bass signals for all three
channels, connect the system as
shown to the left.
Note that the level generated by the
subwoofer will be 6dB greater than
that generated by a single subwoofer.
Hence the sensitivity control of both
subwoofers should be turned down by
6dBu so that the level balance is
maintained between the subwoofer
and the main monitors.
Connection to the centre monitor can
be made from either one of the
subwoofer centre channel outputs.
Two Subwoofers (stereo) in
three channel LCR mode.
To combine the subwoofers into the
system so that one subwoofer
produces the left and centre bass
signals, whilst the other produces the
right and centre bass signals, connect
the system as shown to the left.
Connection to the centre monitor can
be made from either one of the
subwoofer centre channels outputs.
Note that as above the level sensitivity
is 6dBu different from the single
subwoofer system shown in figures 9
and 10.
Guarantee
This product is supplied with a ONE
year guarantee against manufacturing
faults or defects that might alter the
performance of the 1094A/1092A unit.
Refer to supplier for full sales and
guarantee terms. (Not applicable in
the United States)
Accessories
Additional options available :
Bypass switch box 1092-400
1092 Magnetic shielding 1092-403
1094 Magnetic shielding 1094-403
Maintenance
No user serviceable parts are to be
found within the amplifier unit. Any
maintenance of the unit should only be
undertaken by qualified service
personnel. Ensure that if fuse
replacement is required, only fuses of
the appropriate voltage and current
ratings are used. REMEMBER to
disconnect the power supply by
removing the mains cable before fuse
replacement.
Figure 11. Two subwoofers (stereo) in a three-channel system
Figure 12. Two subwoofers (mono) in a three-channel system