Filter
Top Products
5
Reset Button1
Pressing this button will reset the unit and cause the source to re-detect the
EDID. This is useful for when the EDID mode on the rear panel is changed.
Active LED Indicator2
This LED will become active when a valid link between the 1:5 Splitter For HDMI
Over CAT-5 sender and the source has been established.
Power LED indicator3
This LED will become active once the included 24V DC power supply has been
properly connected to the sender unit.
RJ-45 Extension Ports4
There are 2 RJ-45 ports for each of the 4 HDMI extensions to remote locations.
There is one port labeled DDC and once port labeled Video. Both ports must be
used for HDMI extension.
HDMI Jumper Input Port5
A short jumper cable (included) from the lower HDMI output ports must be
connected to these input ports to use the extension feature. There are 4 input
ports that can be used by up to 4 of the 5 HDMI output ports.
24V DC Power Input6
Connect the included 24V DC power adapter between this input port and an
available wall power socket.
EDID Mode Switch7
This switch will determine which EDID mode is used. The two modes are
Internal EDID and External EDID. Please see page 9 for information on how this
feature is used.
HDMI Input Port8
Connect the HDMI source device to this input port. The HDMI signal that is
connected to this input port will be mirrored to the 5 output ports on the rear
panel.
HDMI Output Ports9
There are 5 HDMI output ports that are available for connection to either the
extension jumper inputs (up to 4 outputs) or to local HDMI capable displays.
SENDER PANEL DESCRIPTIONS