Filter
Top Products
16
Programming With Code Search
If your TV, VCR, DBS Satellite System, Cable Box or
Audio System does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching your code by following the steps
below:
1. Manually turn on the device
you wish to program.
2. Press and hold the CODE
SEARCH until the INDICATOR
LIGHT lights, then release
CODE SEARCH.
3. Press and release the device
button for the device you
are programming. The INDI-
CATORLIGHT will blink
once, then remain lit.
NOTE: For AUX programming
(when not an audio code)
press AUX followed by the
device button.
4. Press and release ON•OFF
until your device turns off.
5. When your device turns off,
press ENTER, the INDICATOR
LIGHT will turn off.
Identifying Codes From Your Universal Remote
If you need to find the three-digit code for your TV,
VCR, DBS System, Cable Box or Audio System after
your device is set-up, use this
procedure.
1. Press and hold CODE
SEARCH until the INDICA-
TOR LIGHT lights, then
release CODESEARCH.
2. Press and release the
device button for the code
you are retrieving. The INDI-
CATORLIGHT will blink
once.
94926 Revised Size 2/25/02 4:14 PM Page 17