Filter
Top Products
1010
11
1 2 3
4
5
9
12
11
876 10
1. Speaker Output Connections
Ensure that the speakers are connected observing correct polarity.
2. Fuses
Ensure fuses are replaced with the same type and rating (PP-AM100010 Pictured Above).
PP-AM100010 25A x 3
PP-AM200010 40A x 3
PP-AM300010 40A x 4
3. Power
FUSION amplifiers should be connected directly to the 12V battery terminal with an inline fuse or
circuit breaker as close to the battery as possible.
Ground
When grounding/earthing your amplifier ensure that the location is a good source of ground
(preferably the floor pan). Make sure the metal is clean of paint etc, as a poor earth could
damage your audio system.
Remote Turn On
This connection turns the amplifier on and should be connected to the remote turn on lead from
the Head Unit. If one is not available a switched 12V source must be used.
4. Output Connectors
Line level output for connection to an additional amplifier
5. Input Connectors
Choose the correct length RCA interconnects and run them to the RCA outputs of the source
unit. Avoid running beside other looms and or power cable.
6. Input Level
This control is used to match the input level of the amplifier to the output level of your head unit
1. Turn the amplifier level to zero.
2. Turn the volume of the head unit to ¾ and the bass and treble to zero.
3. Adjust the level control until the desired maximum volume is achieved without distortion.
4. Failure to follow these steps may cause permanent damage to the audio system.
7. Frequency Control
12dB/Octave Low Pass crossover, variable from 32Hz to 320Hz.
8. Subsonic Filter
This is a variable control that filters out all sub bass frequencies below the set point at 12dB/
Octave.
9. Boost Control ( Rear )
Adjust the Bass Boost to the desired level
10. Remote Level Control
Connect the Remote Level Controller using the supplied cable.
11. Power ON LED
Amplifier is operational when illuminated.
12. Protection LED
When illuminated the amplifier is in protection mode due to any of the following fault conditions.
Short Circuit, Thermal, Output Short, DC Offset.
MONOBLOCK AMPLIFIERS
PP-AM100010, PP-AM200010, PP-AM300010