Filter
Top Products
-1-
INSTALLATION AND SERVICE INSTRUCTIONS FOR
MODELS 300GC, 300GCX, 302GC, AND 302GCX
SAFETY MESSAGE TO INSTALLERS
People’s lives depend on your safe installation of our products. It is important to
read, understand and follow all instructions shipped with these products. Listed below
are some other important safety instructions and precautions you should follow:
• This unit must be installed by a qualified electrician in accordance with
all National and Local Electrical Codes, and be acceptable to the Local
Authority Having Jurisdiction.
• Do not connect this unit to the system wiring when circuits are ener‑
gized.
• For optimum sound distribution do not install this device where objects
would block any portion of the front of the speaker.
• All effective warning speakers produce loud sounds, which in certain
circumstances, may cause permanent hearing loss. Take appropriate
precautions such as wearing hearing protection. Recommendations in
OSHA‑Sound Level Standard (29 CFR 1910) should not be exceeded.
• After installation and completion of initial system test, provide a copy of
this instruction sheet to all personnel responsible for operation, periodic
testing, and maintenance of the equipment.
Failure to follow all safety precautions and instructions may result in prop‑
erty damage, serious injury, or death to you or others.
I. GENERAL.
These four SelecTone
®
Models are high output, continuous duty, indoor/outdoor
rated audible signal/amplified speaker devices with internal gain controls. A plug‑in
tone module is required for tone generation. If the use of externally generated tones or
voice signals from a remote amplifier is desired, the plug‑in speaker connector cards
may be used. See the specification section for compatible plug‑in models. These models
may also be used for playback of pre‑recorded messages or tones when used with the
Model TM‑33 Custom Tone Module. The mounting bracket is adjustable to allow posi‑
tioning to obtain desired sound coverage. Speaker projectors on all models are adjust‑
able and may be repositioned to obtain desired sound distribution.
The SelecTone Models 300GCX and 302GCX are designed for use in areas where
Flammable Gases, Vapors and Liquids and Combustible Dusts are not normally pres‑
ent, except for abnormal conditions as defined by the National Electrical Code. These
models are suitable for use in Class I, Division 2, Groups A, B, C, & D; Class II, Division
2, Groups F and G; Class III or non‑hazardous locations only. Reference the product
nameplate for additional information.