Filter
Top Products
6
Before using the LTB, please read and
follow the steps listed below:
1. IMPORTANT Heed all safety warnings when
operating the LTB.
2. Please be sure to check for these items. The
LTB sound system comes complete with 2 LTB-10
Speaker cabinets, 2 speaker cables, 1 microphone
cable and 1 dynamic cardioid microphone.
3. Make sure the power switch is in the OFF
position, the EQ, LOW, MID and HIGH tone controls
are in their 12 o’clock notched positions and all
channel LEVELS, the MAIN and the REV are in their
MIN positions.
4. Next, plug the supply cord into a power source
with the correct voltage.
5. Connect the speaker cables
from the LTB’s SPEAKER
OUTPUT jacks located on the rear
of the LTB mixer to the input jacks
on the speaker cabinets.
6. Connect the cord(s) from any microphones,
instruments, outboard gear or other signal source(s)
to the appropriate input jack(s) on your LTB.
7. Turn all instruments, outboard gear and other
equipment ON before powering up the LTB.
8. Slowly raise the MAIN volume control to its 12
o’clock position. Next, slowly bring up the
appropriate channel input level control (ie: if the
microphone is plugged into the channel 1 inputs, the
appropriate channel control is labeled 1), listening for
the onset of feedback or howling or until the desired
level is reached. The LTB’s overall volume can be
increased by rotating the MAIN
control clockwise.
9. If using external signal processing
devices, slowly raise the appropriate channel EFX
control until the desired level is reached (ie: if the
microphone is plugged into the channel 1 inputs, the
appropriate channel control is labeled 1).
10. When shutting down the LTB, turn OFF the LTB
FIRST then any additional outboard gear,
instruments or other equipment.
For more detail on setting up your LTB, please refer
to the diagrams on pages 9 and 10.
80W
4Ω MIN. LOAD TOTAL
Value
1
Value
2
Value
3
Value
4
Value
5
Value
6
Value
7
Value
8
Value
A
Value
B
Volume
Value
Yes
No
This Illustration was done
by Phil Sanchez
January 27, 1997
POWERPOWER
Stereo CassetteStereo Cassette
PLA
Y
RECORD
PLAY
RECORD
P
AUSE
ST
OP
REW
FF
PAUSE
STOP
REW
FF
9
O
1
9
O
1
0
1
2
2
3
4
0
1
2
2
3
4
LEFT
RIGHT
LEFT
RIGHT
0
1
2
1
2
3
4
-5
0
1
2
1
2
3
4
-5
0
1
2
1
2
3
4
-5
0
1
2
1
2
3
4
-5
T
APE SELECT
NORMAL
C O
r 2
MET
AL
TAPE SELECT
NORMAL
C O
r 2
METAL
RECORD LEVEL
L
R
RECORD LEVEL L R
This full page illustration can be found on page 8.
BASIC SETUP OF YOUR LTB