Filter
Top Products
27
INSTALLING THE
CD PLAYER
Do not, under
any circumstances, connect any
equipment other than Meridian G Series, 500
Series, or 800 Series to any socket marked
COMMS on the back of the product.
The following automatic setup procedure should be used to set up the
Comms correctly between several products:
• Connect one of the DIN COMMS sockets on the back panel of the CD
player to one of the COMMS sockets on another G Series, 500 Series, or
800 Series unit, using the Comms leads provided with the products.
The sequence in which you connect the units is not important.
• Switch all the units to standby.
• Press Clear (remote).
Each unit will display:
Auto
One unit will then be designated
as the controller, and display:
Controller
All the other units will be confi gured
as non-controllers, and display:
Not Con.
If for any reason the automatic setup does not work, make sure you are
operating the remote from a position where all the units can receive the
infra-red, and try again.
If this fails:
• Restore the default operation by selecting one of the standard types; see
Choosing a standard setting, page 30.