Filter
Top Products
30
Configuring the CD
player
Choosing a standard setting
The CD player provides several sets of standard
settings, called Types, which configure all aspects of
the 808.2 into one of a number of alternative standard
configurations.
Types 0 to 3 are factory settings, designed to cater
for the most commonly needed configurations of
associated equipment.
These standard Types are shown in the following table:
Type Description
0 CD player, variable output, all sources
internal.
1 CD Player, fixed output, all sources internal.
2 Preamplifier, fixed output, CD internal, all
other sources external (808.2i only).
3 Preamplifier as above but variable output
(808.2i only).
In addition, your installer may have provided one or
more named User Types, with settings appropriate to
the configuration of equipment when your 808.2 was
installed.
You can reset the configuration of the CD player to any
of these Types to restore it to the state it was in when
it was installed. Note: Selecting a Type will clear any
configuration changes you have made.
To select a standard setting
Warning: this procedure will reset any
configuration changes you have made.
Switch off any power amplifiers that are connected to
the 808.2 and put any digital speakers into standby.
Put the CD player into standby by pressing Off (front
panel or remote).
Press and hold down Volume A (under the front
panel).
•
•
•
The display shows: Type in... 3
Keep holding down Volume A for a further three
seconds.
The display shows:
Type- please wait
Then after a short delay the display shows the current
Type.
For example:
Type 1
Press A or V on the front panel to change the Type
number.
The display shows:
Typing, please wait
Wait for one second, and then put the CD player into
standby by pressing Off (front panel or remote).
Switch on again to use the standard settings you
have selected.
•
•
•
•