Filter
Top Products
1
Introduction
The Extron SPA 12 AAP is a full-range speaker designed for
installation within the enclosures of select HSA (Hideaway
™
Surface Access) and Cable Cubby
®
Series products. It provides
localized, near-field sound coverage for one or more
participants at a conference table.
Mounting the SPA 12 AAP
The SPA 12 installs directly into the four-space AAP opening of
various architectural frames; the Cable Cubby 300, 600, and
800 series; and the HSA 400, and 822 series.
Each SPA 12 AAP includes a rear enclosure and a factory
installed magnet cap to secure it. These pieces enhance the quality
of sound, but are not required for use.
Installation into an HSA 400
To install the SPA 12 AAP speaker into an Extron HSA 400 front
panel, do the following. Several of the steps are summarized in
figure 1, below.
1. Insert the provided polyester fiber foam into the rear
enclosure.
H
SA
4
00
1
2
5
5
0
/6
0
H
z
0
.
5
A
Tighten (2) #4-40 Nuts
w/ Captive Washers
(this side)
Gasket
Polyester Fiber Foam
Speaker Wire
Driver Mount Cap
Threaded
Standoff
Front Grill
Back Can
Tighten (2) #4-40 Nuts
w/ Captive Washers
(this side)
Tighten Lock Nut
& Washer
Remove (2) L-bracket
Mounting Nuts
(this side only)
Extron
HSA 400
Front Panel
Extron
SPA 12
1
2
3
4
5
6
10
8
9
SP
A 12 A
A
P
Figure 1 — Mounting the SPA 12 onto the HSA 400
2. Pass the speaker wire pair through the small hole on the
side of the rear enclosure.
SPA 12 AAP Speaker • Installation Guide