Extron electronic SF 26X Speaker User Manual


  Open as PDF
of 2
 
SF 26X • Setup Guide (Continued)
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron Asia
+65.6383.4400
Extron China
+86.21.3760.1568
Extron Korea
+82.2.3444.1571
Extron Europe
+31.33.453.4040
Extron Japan
+81.3.3511.7655
Extron Middle East
+971.4.299.1800
Extron India
+91.80.3055.3777
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
8.
Secure the speaker wire to the strain relief
tie-down point, using the included zip tie as shown in
the following diagram.
Captive Screw
Connector
Strain Relief
Tie-down Point
Zip Tie
9. Mount the SF 26X.
a. Insert the SF 26X through the bottom of the hole in
the ceiling tile that was cut in step 2.
b. Tighten the four screws (clockwise) until the
locking arms are fully engaged and the speaker is
securely clamped to the ceiling.
Speaker Grille
Locking Arm
ATTENTION: Do not overtighten the screws.
10. Attach secondary support lines if required (see the
diagram below).
Secondary
Support Line
Secondary
Tie off Point
a. Remove the ceiling tile adjacent to the tile where
the speaker is mounted.
b. Attach the secondary support line.
ATTENTION: Do not allow any slack in the
secondary support line.
c. Replace the adjacent ceiling tile.
11. Pivot the tweeter. If desired, pivot the tweeter to aim
the mid and high frequencies to the desired spot, as
shown below.
ATTENTION: The tweeter can be pivoted only. Do
not attempt to rotate the tweeter.
12. Install the grille. Position the outer perimeter of the
grille into the groove of the speaker bafe. Six magnets
pull the grille securely into place.
Speaker Grille
NOTE: Grille hooks are provided for removal of the
grille after installation.
68-2222-50 Rev B
11 13
 previous