Extron electronic FF 120T Speaker User Manual


  Open as PDF
of 4
 
4
68-1450-52
Rev. C
10 12
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Europe
+800.3987.6673
(Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
(Inside Asia Only)
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+4000.398766
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
Inside India Only
+91.80.3055.3777
+91.80.3055.3737 FAX
© 2012 Extron Electronics All rights reserved. www.extron.com
11. Set the speaker on top of a T-rail making sure to hide the edges behind the grid rail.
12. If secondary support cables are being used, install them (see the illustration below).
ATTENTION: DO NOT allow any slack in these support cables.
NOTE: Observe all applicable building codes and local ordinances when installing the speaker.
a. Temporarily remove a ceiling tile adjacent to the speaker and set it aside.
b. Connect a secondary support cable through the secondary attachment point, and attach it to one of the bendout tabs
located on either side of the speaker.
c. Attach the other end of the cable to a sturdy part of the building (studs, roof struts, and so on).
d. For additional secondary support cables repeat as needed (see the FF120T User Guide for further details).
e. Replace the ceiling tile removed in step 12a.
13. Check all wiring before powering up the amplier.
Extron
FF 120T
Ceiling
Speakers
Ceiling Tile
Ceiling Tile
Rails
T-rail (1)
2' by 4' Ceiling Tiles
Extron
FF 120T
Ceiling
Speakers
Ceiling Tile
Ceiling Tile
Rails
T-rail (1)
2' by 2' Ceiling Tiles
ATTENTION: Repeated bending of the tab may cause it to break off.
Route the seconday support cable
through the secondary attachment point
and bendout tab.
Anchor this end to a
suitable secure point.
Secondary
Support Cable
Bendout Tab (2)
 previous