Filter
Top Products
DVI DA2 and DVI DA4 • Installation and Operation
2-11
Operation
1. Connect the power supply (see page 2-10).
2. Connect and power on the local monitor (see page 2-8).
3. Connect and power on any other output displays (see
page 2-8).
4. Connect and power on the source device (see page 2-8).
N
Output 1 (LOCAL OUTPUT) is used as a DDC
reference and must be connected to the distribution
amplifier before the source device. If the source device
cannot communicate with the local monitor when it
is being powered on, it may not be able to send a video
signal or the signal may have the wrong resolution or
refresh rate.