Filter
Top Products
Front Panel Features
Power LED
The Power LED lights green when the unit is receiving power.
Config USB Port
Connecting to the USB Port
The mini type B USB port is located on the DP DA2 front panel. It can be used to connect
the distribution amplifier to a host computer for updating firmware or for configuration
using SIS commands. Alternatively, use the RS-232 captive screw connector (see page
8). For complete information about SIS commands, see the “SIS Commands” section on
page13.
1. Connect a USB A to mini B cable between the USB Config port on the front panel of
the DPDA2 and the USB port of the PC.
USB Cable
Type A
USB
Mini Type B
USB
USB 1
USB
Ports
Computer
DP DA2 Front Panel
DP DA2
DISPLAYPORT DISTRIBUTION AMPLIFIER
INPUT
OUTPUTS
12
SIGNAL
HDCP
CONFIG
Figure 5. Connecting a PC to the DP DA2 Front Panel USB Port
DP DA2 • Panel Features 9