Filter
Top Products
Input cable lengths
The maximum input cable length is 250 feet (76 m) for a transmission rate of 165 MHz; a
cable length of up to 200 feet (61 m) can be used for a transmission rate of 225 MHz. Longer
cables may be used with a lower rate. High quality cable can increase the distance and rate of
transmission. Other factors affecting the maximum transmission distance and frequency include
the sensitivity of the input source and the display device.
NOTE: Avoid using couplers and adapters between cables, as this can result in signal
degradation.
This table shows the maximum cable lengths recommended for each resolution.
Video Resolution
Maximum Distance
(powered by source)
Maximum Distance (powered by
external power supply)
720p 150 feet (46 m) 250 feet (76 m)
1080i 150 feet (46 m) 250 feet (76 m)
1080p 8 bit 150 feet (46 m) 200 feet (61 m)
1080p 10 bit 150 feet (46 m) 175 feet (53 m)
1080p 12 bit 125 feet (38 m) 150 feet (46 m)
1024x768 (60 Hz) 150 feet (46 m) 250 feet (76 m)
1280x1024 (60 Hz) 150 feet (46 m) 250 feet (76 m)
1600x1200 (60 Hz) 125 feet (38 m) 200 feet (61 m)
1920x1200 (60 Hz) 125 feet (38 m) 200 feet (61 m)
NOTE: When the source is a PC, Extron recommends the HDMI 101 Plus be powered by
an external power supply.
Rear Panel Connections
HDMI INPUT
2
1
HDMI 101 Plus
POWER
12V
0.2A MAX
HDMI OUTPUT
4
3
Figure 3. HDMI 101 Plus Rear Panel
c HDMI Output — Plug an HDMI cable from an output device into this female HDMI Type A
connector, following the pin configuration shown in the table on page 3.
Secure the HDMI connector to the HDMI 101 Plus with the LockIt
™
HDMI lacing bracket
provided (see the LockIt HDMI Lacing Bracket Installation Guide at www.extron.com).
NOTE: Use cables that are 15 feet (5 m) or less for the output.
HDMI 101 Plus • Panel Features 4