Emerson SB110 CD Player User Manual


 
5
This CD player requires either two (2) “AA” cell batteries (not included) or the AC
adapter (not included).
BATTERY INSTALLATION
The battery indicator ( ) will appear in the CD display when the batteries need
replacing.
1. Open the CD Compartment, then open the battery
compartment door by pressing in on the tab and then
lifting it.
To prevent the possibility of losing the
cover, it cannot be removed.
2. Insert two (2) “AA” cell batteries (not included)
according to the polarity diagram inside the battery
compartment. Alkaline batteries are recommended for the longest playing time.
AC OPERATION
To operate the unit using AC power, connect the AC adapter (not included) to a 120V,
60Hz AC outlet only. Plug the small end into the DC 4.5V jack on the side of the unit
and connect the other end into the AC outlet. The batteries are automatically
disconnected when the AC adapter is used.
CAUTION: When not using AC power, disconnect the AC adapter from the wall
outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet
hands. Fully insert the plug without exposing any part of the blade.
POWER SOURCES
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with
fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or
injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
Input: 120V 60Hz AC
Output: 4.5V DC, 500 mA.
Plug: 1.7 mm Female Type with Positive Cente
r
, UL Listed.
Positive (+)
Negative ( )