Filter
Top Products
15
PLAYING CASSETTE TAPES
1.) Open the cassette door by pressing the key..
2.) Place a pre-recorded cassette tape into the slots on the inside of the door with
the exposed tape facing up and the full reel on the right side.
3.) Move the FUNCTION selector to the OFF/TAPE position.
4.) Press the cassette key to begin playback.
5.) Adjust the VOLUME + / – controls as desired.
6.) To advance the tape rapidly press the key. To stop the tape before it ends
press the key..
7.) To rewind the tape rapidly press the key. To stop the tape before it ends
press the key..
8.) When the tape ends the Automatic Stop System releases the key and shuts
off the tape motor. You may then open the cassette door, remove your tape,
turn it over and play the other side if desired.
9.) When you are finished listening press the key to stop the tape. Open the
door, remove the tape and close the door. If you are playing a tape and then
switch to the RADIO or CD function be sure to disengage the tape mechanism.
This prevents excess wear and tear on the mechanism.
IMPORTANT:
Always press the key to shut off the tape motor before opening the cassette
door to remove your tape. The Automatic Stop System does not function in the
Fast Forward and Rewind modes. When the tape ends in the and modess
the motor continues to run. You must press the key to shut off the motor
before opening the door to remove your tape.
PD6922_B111003.p65 10/11/2003, 11:1215