Filter
Top Products
5
Installation
FM antenna wire
The single trailing wire from the unit is the FM antenna. This should be positioned for
best FM reception (do this when you're tuning - in to radio stations–see page 18).
Installing the remote control batteries
At the back of the remote, press the indented area and slide open the battery
compartment.
Note–Most functions can be operated by the remote.
However, the controls are also present on the front panel (below the flap). In
general you shouldn't need to lower the flap unless you lose the remote.
Install 2 batteries type AA (not included). Make sure the direction of the batteries is as
shown above.
Once the batteries are inserted, replace the battery cover.
If the remote stops working, it's most likely that the batteries need replacing. Always use
leakproof batteries.
Dispose of old batteries safely. Do not throw them in the fire.
If you're not using the remote for a few weeks or more, remove the batteries.