Emerson HD7999 CD Player User Manual


 
10
NORMAL CD PLAYBACK
Make sure you have installed the batteries.
Make sure the HOLD switch is set to the Off(left) position.
Make sure to set the VOLUME control to a low setting before you put on
the headphones.
IMPORTANT:
This CD player can play normal CDs plus CD Recordable (CD-R) and CD
Rewriteable (CD-RW) discs. However the playability of CD-R and CD-RW discs
may be affected by the type of software that was used in rippingthe tracks from
the original discs and burningthe tracks onto the blank media. Playability may
also be affected by the quality and condition of the blank media you use for
recording. 100% compatibility cannot be guaranteed. This is not an indication of
any problems with your player.
1.) Slide the CD door OPEN switch to the right to unlock
and open the CD door.
2.) Place your CD on the center spindle with the printed
label side facing up. Press downward on the disc near
the center hole until the disc is fully seated on the
spindle.
3.) Close the CD door and connect the headphones to the headphone jack (green
color) by pushing the headphone plug the into headphone jack until a click’
sound is heard.
4.) Press the PLAY/PAUSE button to begin
playback. The – – flashes while the player
reads the disc. The total tracks will appear
briefly in the display and then the playback
will begin on track 1. The display will show the track being played.
5.) Adjust the VOLUME, and BASS controls as desired.
OPEN
HD7999_031004.p65 11/3/2004, 10:1510