Emerson ES2 Speaker System User Manual


 
12
Setting The Clock
You may use the buttons on the remote or the touch panel screen for this
operation.
Using remote or touch panel screen.
1. Press the STANDBY (POWER) button Oto switch the unit on.
2. Press the AUX button. (Note the time setting appears at the center of the display.)
3. Press MEMORY so that the hour digits flash, then immediately press B or
F to set the correct hour.
Note: Check the AM / PM indicator (to the left of the hour) to ensure you make the
correct setting.
4. Press MEMORY again so that the minute setting flashes, then immediately press
B or F to set the correct minute.
5. Press MEMORY once more to finish the clock setting.
The display stops flashing and the clock begins to run.
Note:
If ever you find the whole time display is flashing, this means that the clock
needs to be re-set (possibly due to the unit having been disconnected from the
AC outlet, or a power interruption.)
Clock setting can be done even if unit is at Standby mode.
ES2_ib041503.p65 15/4/2003, 9:3612